Nylon Sanding Fleece Disc with permanently integrated clamping mandrel
SNDDISC-NYLFAB-ARBOR-D100MM
Art.-no. 05852100
EAN 4024835858915
Register now and access more than 125,000 products
- The coarse-textured and elastic non-woven cleaning abrasive made of synthetic fibres with evenly embedded silicon carbide boasts a flexible, open structure and high cleaning performance.
- Perfect adjustment to the workpiece geometry for optimal surface contact.
- Minimal clogging with surface dust.
- Uniform, reproducible sanding results.
- The reduced heat generation ensures cool sanding.
- Ensures fresh abrasive grain is continuously available.
- Consistent, uniform results and a clean, residue-free surface.
- Minimised risk of damaging the workpiece surface or removing too much material.
- The material is free of metals susceptible to corrosion and reliably prevents contamination of the surface of the material.
- For use on drills, die grinders and flexible shanks.
- Plastic support flanges that can be snapped off in stages.
- Make sure that the flange diameter corresponds to at least half the disc diameter.
- The maximum permissible speeds must not be exceeded.
- Work only with appropriate protective equipment, e.g. safety goggles, gloves, hearing protection etc.
- Coarse non-woven cleaning abrasives are not suitable for edge sanding. Therefore, only sand along and not against material edges.
- Observe the operating instructions.
Datasheets(X)
Materials to be processed:
For universal use on virtually all materials. Especially for stainless steel, steel, non-ferrous metals, wood and plastic.
Cleaning welding seams, metal surfaces, wood and plastic
Removing tempering colour, scale, rust, corrosion, dirt and oxide layers, coatings, paints, old brushed-on coatings, synthetic resins, adhesives, gasket residues and cement and concrete residues.
Structuring, line matting, preparation and roughening up of surfaces
Light deburring work
Cleaning vehicle underbodies and for various other tasks in car body construction
Diameter x width x shaft diameter | 100 x 26 x 6 mm |
Min./max. recommended rotation speed | 3500-4500 rpm |
Max. rotation speed | 6000 rpm |
Min./max. rotation speed at nominal load | 3500-4500 rpm |