EURASEAL O-300 window sealing tape for outdoor use
WNDWSEALTPE-(O-300)-SA/FSA-W140MM-L25M
Art.-no. 0875583140
EAN 4056807841946
Register now and access more than 125,000 products
Quick and simple joint sealing
- Full-surface adhesive on the masonry side and adhesive strip on the window frame side of the tape
- Can also be corrected for a short period after bonding, since maximum adhesion increases over time
- Can be used in a wide variety of applications due to slots in backing film
- Very good long-term adhesion
- Can be plastered over
RAL-compliant seal
- Tighter seal on the inside than the outside against vapour diffusion.
- Meets the installation requirements of the German RAL quality assurance association for windows and doors
This product is classified in accordance with EMICODE® (EC1 Plus). EMICODE® is an independent labelling system for low-emission products, based on specified test methods and limit values.
For surface temperatures of +5 °C or below, and/or on mineral and highly absorbent surfaces, use adhesion primer spray or butyl/bitumen primer.
EMICODE EC1plus: Very low emission – the EMICODE classification system characterises the environmental and health compatibility of construction products. The lowest-emission products bear the EC1plus mark.
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
- For sealing window and door joints in new buildings and redevelopments.
- For smooth masonry reveals.
Colour | Anthracite |
Backing material | Non-woven |
Width | 140 mm |
Thickness | 0.7 mm |
Length of roll | 25 m |
Min./max. processing temperature | 5 to 35 °C |
Min./max. temperature resistance | -40 to 80 °C |
Building material class/conditions | B2 - Normally inflammable / in accordance with DIN 4102 |
Ultraviolet resistance | 3 months, outdoor weathering |
Max. air layer thickness equivalent to water-vapour diffusion | 2 m |
Min. air layer thickness equivalent to water-vapour diffusion | 2 m |
Shelf life from production/conditions | 12 Month / at 5°C to 25°C |